Tile & Grout Cleaning
Tile Floor Cleaning in Jackson, TN
4.9 (278 reviews)2 min read
Tile floor cleaning in Jackson homes handles traffic soil, the grit walked in and ground into the grout lines. Grout sits slightly below the tile, so soil and mop water collect there and soak in. We rinse it out with 200 to 240°F water at about 1,000 to 1,200 PSI and vacuum it to the truck.
Tile floors go dark at the grout line. Grout sits a little lower than the tile around it. Anything liquid on the floor runs toward it, and anything gritty gets pushed into it. Grout is also porous cement, so it collects soil and then absorbs it.
Mopping speeds this up. A mop lifts soil off the tile, holds it in the bucket water, then puts most of it back down. The tile looks fine because it does not absorb. The grout does, so the soil in that water settles in and stays.
On a whole floor, we clear it, put cleaner down with a pump sprayer, and then rinse at about 1,000 to 1,200 PSI with water heated to 200 to 240°F. The tool vacuums the water and soil out to the truck as it rinses, so a big area gets done without dirty water sitting in your house. Edges, thresholds and toe kicks get done with hand tools.
Entry halls get the most attention. Almost all the grit in a house comes in through the doors, from muddy spring yards to church shoes on a Sunday. Call (731) 437-0006 or request an estimate.
Benefits of Floor Tile Cleaning
- Soil rinsed out of the grout lines instead of spread by mopping
- Rinse water vacuumed out to the truck as it goes down
- Extra attention at entry halls, where grit comes in
- Whole floors done on one visit
- Usually ready for use in 1 to 2 hours
Who This Is For
- Jackson homes with tile through kitchens, entries, halls and living areas
- Anyone whose grout lines have darkened while the tile still looks fine
- Open floor plans where the grout sets the whole look
- Homes being listed, shown or turned over
- Offices, churches, shops and other commercial tile floors
Our Process
Look the Floor Over
We go over the whole area with you and note the worst spots. We check for failing grout, hairline cracks, mismatched grout colors, old repairs and the condition of any color sealer.
Clear the Floor
Mats, light furniture and anything loose come off the tile.
Apply the Cleaner
Cleaner goes across the tile and grout with a pump sprayer and gets time to work.
High-Pressure Rinse and Vacuum
We rinse at about 1,000 to 1,200 PSI with 200 to 240°F water, area by area. The tool vacuums the water and soil out to the truck in the same pass.
Edges by Hand
Baseboards, thresholds and toe kicks are done with hand tools.
Look It Over Together
You look at the floor with us before we leave.
What's Included
- A check of the whole floor, including grout damage
- Floor cleared
- Cleaner applied with a pump sprayer
- High-pressure hot water rinse, vacuumed out to the truck
- Extra passes in traffic lanes and entry halls
- Hand tools at edges and thresholds
- A look at the finished floor with you
Realistic Results, Honestly
We would rather set an honest expectation than make a promise we cannot keep.
- Grout under rugs, furniture and in closets has not aged like the grout by the back door. A clean floor can still show shade differences between covered and open areas. That is age.
- Entry halls take abrasive grit. Over years it can dull tile glaze and erode the top of the grout. Wear does not clean out.
- Some lines are stained for good. Where dirty mop water has soaked in for years, cleaning takes the line as far as it can go. Color sealing is the next step if the remaining shade bothers you.
- An unsealed floor starts absorbing again with the next mop bucket. Sealing needs clean, fully dry grout, so it comes after the floor dries.
- Tile floors are usually ready for use in 1 to 2 hours, and they are slippery while damp. Plan around that, especially with children, pets or anyone unsteady on their feet.
Safe for Your Family and Pets
We use family safe, pet safe products across the whole floor, and the rinse takes them out. The water is vacuumed up as it goes down. The floor is slick while damp, so keep everyone off it until it has dried.
What Customers Say
“They cleaned and sealed all of our tiled floors with a satin urethane. We were very pleased with the results!!”
David B. · Google review · September 2022 “Great Service - Great Results! We would recommend HydroClean for your Carpets, Upholstery or Tile floors.”
Barry C. · Google review · July 2022
Floor Tile Cleaning Questions
How long does a tile floor take to dry?
Tile floors are usually ready for use in 1 to 2 hours. Humidity changes that, and running your heat or air helps. Take care walking on it while it is still damp.
Is mopping making my floor worse?
It can be. A mop lifts soil off the tile, then puts much of it back down in dirty water, and that water settles into the grout. Changing the water often helps, and sealed grout helps more.
Do you clean under furniture?
Light pieces come off the tile when we clear the floor. Heavy pieces, appliances and anything fragile stay in place. If you want the tile under a heavy piece cleaned, have it moved before we arrive. Grout under furniture has aged differently, so expect a shade difference if a piece moves later.
How often should a tile floor be professionally cleaned?
It depends on traffic. Kitchens, entry halls and showers need it soonest. Many families have tile done with their spring or fall cleaning. If you want tile done on the same visit as carpet, tell us when you call so it is on the estimate.
Wondering about cost? We do not post prices, but you can see what affects the price of tile and grout cleaning.
Need Floor Tile Cleaning in West Tennessee?
Request an estimate from our Jackson team. Tell us what needs cleaning, which rooms and the rough sizes. We respond to requests on the same business day. We prepare the estimate, you approve it, and we schedule a time. You get a chance to look at the work before we leave.
Trusted by our neighbors in Jackson, West Tennessee since 2010. Family safe, pet safe.
Related Services
Grout Cleaning
Our main tile service: soil rinsed out of porous cement grout with hot water and pressure.
Ceramic Tile Cleaning
Cleaning for glazed ceramic tile in Jackson homes, with the grout lines rinsed out at high pressure.
Grout Sealing
A penetrating sealer that helps porous grout shed liquid, applied only once the grout is clean and fully dry.